Welcome to visitUHF RFID Reader,UHF RFID Module,UHF RFID Antenna,UHF RFID TagOfficial website!

> MTCP01

Product Name:MTCP01

Product introduction：General TCP/IP module, used for mainboard network communication, stable and high-speed. With driver and supporting software, you can configure IP, server, working mode, automatically obtain IP, and automatically obtain n

product details

Module introduction

MTCP01 network serial port transparent transmission module (NRP-MTCP01), through the network to TTL level serial port, can realize the two-way transparent transmission of network data and serial data, with TCP CLIENT, TCP SERVER, UDP SERVER, UDP CLIENT 4 working modes, serial port baud The highest rate can support up to 921600bps, which can be easily configured through the host computer software, which is convenient and fast.

Features

● Realize two-way transparent transmission of serial data and network data

● Support 10/100M, full-duplex/half-duplex adaptive Ethernet interface, compatible with 802.3 protocol

● Support MDI/MDIX line automatic conversion

● Support 4 working modes: TCP CLEINT/ SERVER and UDP CLEINT/ SERVER

● The serial port baud rate supports 300bps ~ 921600bps

● Support up to two independent serial ports at the same time, independent transparent transmission

● Serial port TTL level, compatible with 3.3V and 5V

● The serial port supports 5, 6, 7 or 8 data bits and 1 or 2 stop bits

● The serial port supports odd, even, no parity, blank 0, mark 1 parity mode

● The serial port supports full-duplex and half-duplex serial communication, and supports automatic switching of RS485 transceiver

● Support DHCP to automatically obtain IP address function

● Support DNS domain name system

● Support 0～2000ms serial port timeout setting ● Network parameters, serial port parameters can be configured through the host computer

● Support KEEPALIVE mechanism

Pin description

Name	Type	Description
RSTI	Input	External reset input, active low
RESET	Input	Restore factory settings, chip power-on detection, active low
DIR	Output	Used to control the RS485 transceiver switch
RXD1	Input	Serial data input of asynchronous serial port 1
TXD1	Output	Serial data output of asynchronous serial port 1
GND	Power	Common ground
VIN	Power	Power input terminal, the default is 5V, TTL version when J1 is shorted, the input is 3.3V
CFGO	Input	Serial port configuration mode setting pin, built-in pull-up, when low level is detected, enter the serial port configuration mode, high level to exit the configuration mode
RXD2	Input	Serial data input of asynchronous serial port 2
TXD2	Output	Serial data output of asynchronous serial port 2
TCPCS	Output	In TCP client mode, connection (channel 1) status indication, low level is active